GC1145 material is in character in cut off and more powerful performance is shown in grooving application. Mix through buildup point strength fight wear away ability, in normally difficult stainless steel is cut off cutting tool life or cutting rate can raise in treatment. When to choose GC1145 to undertake stainless steel kind material (ISO-M) and difficult process kind of data (of ISO-S) cut off and grooving treatment cuts off stainless steel to be used at discontinuous cutting to become rotate speed is finite with the expression in be being machined when cutting rate is low material is in high-powered GC1145 character in cut off and more powerful performance is shown in grooving application. Mix through buildup point strength fight wear away ability, in normally difficult stainless steel is cut off cutting tool life or cutting rate can raise in treatment. The test through the client proves, this cutting tool and competitor product photograph are compared, cutting tool life is as high as 300% to try. Cut off width narrowly to still enough clip holds security to use GC1145 bit the security that GC1145 of can managing material improves cutting point. Point can be when cutting what carry point in the action of counteractive cutting in longer time is complete. Use GC1145, you can be cut more greatly surely on same bit width, thereby managing material. A representative application of GC1145 is to cut off stainless steel club to expect. When in the center that approachs good stuff cutting rate falls, the tall tenacity that should thank GC1145 helped us resist the puissant action that cuts bits. When discontinuous cutting, GC1145 can be used more qualitative than congener material higher cutting rate, and life of unapt loss cutting tool. Material describes GC1145 to hold concurrently character inferior micron bond hard alloy and deposit of physical gas phase (PVD) oxidation film. The point that this makes this material qualitative can hold a wearability and tall tenacity concurrently. Case GC1145 the feed speed of 3 times and the spare parts of cutting tool life of 250% : Round good stuff: Condition of cutting of austenite stainless steel: Oily refrigeration operates: Exterior cut off, razor blade of GC1145 of rough machining competitor: Competitor N123G2-0300-0002-CM material is qualitative: Competitor GC1145 rotate speed (R/min) : VC(m/mi) of 9361123 cutting speed: 100120 into lead Fn(mm/r) : 0. 050.
15 cutting length (Mm) : 55 sheet cutting time (Min) : 0.
150.
Life of 05 cutting tool (several) : 120300GC1145 with wearing away safely mode, the time that uses 1/3 processed the work of 250% more CNC Milling
CNC Machining